Click “Communication | Configure Drivers”, then choose “Remote Devices via RSLinx Gateway. The client does not need an activation installed to access the gateway. Now that the gateway is set up, you are ready to configure the driver on the client. Since RSLinx sometimes runs as a service, I always reboot the computer if possible. At this point, under “Communications” choose to configure the gateway.īe sure to check “Enable RSLinx Gateway”, then choose “Apply” and “OK”.įinally, restart RSLinx. Also, set up any drivers you need for your communication cards. The Title Bar of RSLinx should reflect this. On the Gateway Computer, be sure you have an RSLinx Gateway activation installed. You also improve your flexibility to access the Data Highway Plus network from potentially anywhere in the plant. Since the cost of a 1784-KTx module (or any other network module) is so high, you will save money in the long run. FactoryTalk View SE Trends and Data Log.
- Beginning a FactoryTalk View SE Project.
- Derivative Settings for ControlLogix PID Enhanced.
- Integral Settings for ControlLogix PID Enhanced.
- Proportional Settings for ControlLogix PID Enhanced (PIDE).
-
Proportional, Integral, Derivative (PID).